seaming carpet::Start by removing the moldings around the floor and take the door off the entrance, so you can get the old carpet out and the new carpet in easier seaming carpet

seaming carpet::Start by removing the moldings around the floor and take the door off the entrance, so you can get the old carpet out and the new carpet in easier.
Start at one end and pull the carpet off the tackless strips and roll it up in sections.
Remove the existing tackless strips and make sure the floor is clean and dry.
Install new tackless strips around the perimeter of the room, but not in front of doorways.
Laying the underpad put the underpad down in strips that overlap the tackless strips.
Trim the excess underlay along the inside of the tackless strip and use duct tape to seal the seams.
Laying the carpet to install carpet properly, you need to start with a piece that overlaps the edge of the floor by 4 to 6 inches.
The overlay can then be trimmed so the carpet fits properly.
To cut your first section, measure the room at its longest point and add 6 inches to that measurement.
Mark the back of your carpet on both edges with that measurement and join the two marks with a chalk line.
Fold the carpet over on itself, and using a straight edge and a sharp utility knife, cut through the backside of your carpet.
Be sure to place a piece of scrap board underneath your cut line to protect the underlying carpet.
Be sure the carpet pile is running the same way in both pieces, and that the carpet piece is large enough to overlap the wall by 4 to 6 inches, as well as overlapping the first piece of carpet by 4 to 6 inches.
After cutting the carpet, center a piece of seaming tape on the floor underneath where they join, adhesive side up.
Attaching the carpet use a knee kicker to attach the carpet along one edge.
This will stretch the carpet over the tackless strip where the tacks will grab it and hold it firmly in place.
A carpet stretcher will finish attaching the carpet.
A carpet stretcher is similar to knee kicker, but much longer.
Put one end of the carpet stretcher against the wall where the carpet is already attached and place the other end about 6 inches from the far wall.
The carpet stretcher also has teeth to grip the carpet, and when you push on the activation lever, it will stretch the carpet over the tackless strip near the far wall.
Work your way around the room stretching the carpet over the tackless strips, and trim the carper near the wall with a utility knife or a wall trimmer.
Finishing up using a stair tool, tuck the carpet down into the gap between the tackless strips and the wall.
At the doorway, trim the carpet so the edge is centered under the closed door and install a door edge strip.
Finally, cut any vent openings and install the molding on the baseboards.
Stretch your back, check to see if your knees still work, and then take some time to admire what all your hard work has accomplished.
Murray anderson is an experienced freelance writer with articles published in both the united states and canada.
He has written on a wide range of topics, but specializes in home maintenance and.
seaming carpet::The tools required are carpets, seaming knife, blade,
iron for pressing, and seaming tape seaming carpet